Robotics Sportster Flash x2 Guide de l'utilisateur télécharger pdf (Page 17)

Sportster Flash x2 - User’s Guide 13

Testing Your Installation

1. To test your modem and software installation, perform the

software function that puts your computer in Terminal mode. In

Terminal mode, a cursor appears on your screen, allowing you

to send commands directly to the modem.

2. To determine if your computer and modem are communicating

properly, type the following command: AT E1 Q V1<Enter>

· If the COM port and IRQ settings are correct on your

modem and in your software, the modem responds: OK

· If the characters you type do not appear, no OK appears, or

double characters appear, see the Troubleshooting section

in this guide.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 70 71

Pas de commentaire

Robotics Sportster Flash x2 Guide de l'utilisateur Page 17