Robotics Sportster Flash x2 Guide de l'utilisateur télécharger pdf (Page 12)

8 Sportster Flash x2 - User’s Guide

Hardware Installation Steps

Before you begin the modem installation, turn off your computer and

any attached devices, such as a printer. Follow these steps to install

your modem. Refer to the drawing below of the back panel.

1. Connect the serial cable to the modem and to the computer.

When looking for your serial port label on the back of your

computer, select COM, MODEM, RS-232, or SERIAL.

Do NOT select AUX, GAME, LPT, or PARALLEL.

Note which serial port you selected.

This information will be necessary when installing your

communications software.

2. Plug the power adaptor into the power socket and into a

standard wall outlet.

3. Plug one end of the phone lead into the telephone socket

(labelled with a wall plug icon on the bottom of the case) and the

other end into a phone wall socket.

4. If you wish to use your modem and phone through the same

phone wall socket, plug your phone's lead into the modem's

other socket (labelled with a phone icon on the bottom of the

case), using the supplied Tail lead adaptor.

5. An external powered speaker must be connected for speakerphone

use. For more information, see the next page and consult your

software manual.

Power

on/off

To speaker

To phone

To power

source

To wall

socket

To computer

Volume

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 70 71

Pas de commentaire

Robotics Sportster Flash x2 Guide de l'utilisateur Page 12