Robotics COURIER Spécifications télécharger pdf (Page 39)

4-8 Courier V.Everything External Modem: Getting Started

Remove the modem (printed circuit board), carefully easing

the voice/data switch out of its opening in the front panel.

Locate jumpers J4 and J6.

MI/MIC Jumpers

Figure 4-1. Location of the MI/MIC Jumpers.

Set the jumpers as shown:

From

Replace the modem and reconnect the cables.

CAUTION: When you power on the modem there will

be potentially hazardous voltage, particularly near the

phone jacks. Do not touch the board when the power is

on.

Power on the modem. Check to see that the Off Hook (OH)

status light goes on. If you dialed a number, listen for an

answer tone from the remote modem.

Then drop the DTR signal. The modem should go on hook

and the OH status light should go off.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 63 64

Pas de commentaire

Robotics COURIER Spécifications Page 39