Robotics COURIER Spécifications télécharger pdf (Page 36)

Other Features 4-5

Table 4-1. Voice/Data Switch Commands.

S32

Value Voice/Data Switch Function Related Command

0 Disabled _

1 Voice/DataOriginate Mode ATD (Chapter 3)

2 Voice/DataAnswer Mode ATA (Chapter 3)

3 Redial Last Number ATDL (Chapter 3)

4 Dial Number Stored at position 0 ATDS0 (Chapter 3)

5 Auto Answer On/Off Toggle ATS0=0 or 1 (Chapter 3)

6 Reset Modem ATZ (Chapter 4)

7 Initiate Remote Digital Loopback AT&T6, S16=8 (Chapter 15)

8 Busy Out the Phone Line Toggle _

9* Execute Stored Command AT&ZC=

(Chapter 4)

* The modem is shipped from the factory set at S32=9. If a command string has

been stored (&ZC=

), the Courier sends the stored command string when you

push the Voice/Data switch. If no command string is stored, the Courier still

reports that S32=9, but actually behaves as if it is set to S32=1, Originate mode.

You can program the voice/data switch to execute a stored

command string when pressed. The following example assigns a

command string that displays the link diagnostics screen when

you press the voice/data switch.

AT&ZC=I6 <Enter>

Set the voice/data switch function to execute stored command

string by setting Register S32 to 9 with the following command:

ATS32=9 <Enter>

Note that you can reset the voice/data switch at any time to one

of the other available functions. Additionally, you can overwrite

the stored command string with a new one at any time.

Once you've stored your command string and set Register S32,

press the Voice/Data switch whenever you want the Courier to

send the command string.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 63 64

Pas de commentaire

Robotics COURIER Spécifications Page 36